En ce moment :Genshin Impact, Valhalla, Breath of the wild, Animal Crossing, GTA 5, Red dead 2
PCPS5Xbox SeriesSwitch 2
Liste des sujets
Problème Fallout 3...
ParkMan
Niveau 34
22 juin 2015 à 19:32:02
Bonjour, donc j'ai les fameux crash à la sortie du bunker, et des fois ailleurs, j'ai trouvé la manip à faire
"Yeah I had to limit my quad core to using 2 cores. I still get the occasional freeze but it's now rare and nowhere near the amount I WAS getting.
The simplest way for me was to locate and edit a line on the fallout.ini file.
It is located in
C:\Documents and Settings\USERNAME\My Documents\My Games\Fallout3 for XP
or
C:\Users\USERNAME\Documents\My Games\Fallout3 for Vista/Win 7
Open the fallout.ini and scroll down a little, look for the following line:
bUseThreadedAI=0
It is in the [General] section of the file, if you pass [Display] you've gone slightly too far down. Change it to:
bUseThreadedAI=1
Hit enter (so it adds a new line) and add the following line:
iNumHWThreads=2
So the two lines should look like this:
bUseThreadedAI=1 iNumHWThreads=2
Save the file and close and you're done.
I also had to run in windowed mode to avoid the CTD until I discovered that disabling extended desktop display mode - by either setting it to clone mode (same on both displays) or single display enabled it to run fullscreen. "
Mais j'arrive pas à supprimer la ligne dans les dossiers, c'est intouchable, y a une solution ?
[Happisme]
Niveau 10
22 juin 2015 à 19:33:32
Moi j'ai mieux, il se lance même pas sous Windows 8.1 J'ai lu quelques trucs sur internet à ce sujet mais juste qu'il ne se lance pas de base c'est quand même fort
Essaye de déplacer le fichier ailleurs (bureau par exemple) et ensuite fait la modif et remet le fichier dans le dossier de base
Message édité le 22 juin 2015 à 19:34:57 par [Happisme]