J´ai telecharger un parachute et j´arrive pas a l´ouvrir
THIS SET OF FILES IS IN THE PUBLIC DOMAIN.
Copy the Skydiver Folder into your FS9 Aircraft Folder.
If you have already installed the Parafoil with its gauges, you do not need to install these gauges. You will need to install the Parafoil in order to land.
To install these gauges just copy the Gauges Folder into the Gauges Folder within FS9.
Copy the four flies: Skydiver.flt, Skydiver.wx, Skydiver2.flt and Skydiver2.wx into
C:\My Documents\Flight Simulator Files or a corresponding location on your system
where they will give you two starting conditions or "Flights" for your first freefall flights. Both Skydiver and Skydiver2 start at the same speed and altitude (20,000ft +) over the Huntsville, Alabama, airport (KHSV). But Skydiver has a wind profile while Skydiver2 has calm air - no wind. The wind profile makes a slight difference in the way the Skydiver flies and a big difference in the way the Parafoil flies after your transition.
You can set up a Skydiver flight anywhere you wish by taking off in the King Air 350 or the Learjet 45, climbing to over 20,000 ft somewhere close to your intended landing zone, slowing to about 150 KIAS, and then switching to the Skydiver ´aircraft´. After the switch, save that Flight condition for repeated jumps.
During your flight you can watch the flight either from spot view or from the normal ´cockpit view´ where you will see some digital instruments. You will also see a flap display and a landing gear switch. The flaps control the legs and the gear switch controls the arms. These are there to let you know what position you have selected. See the Checklist and the Reference text for more information on what these controls do for you.
Use your joystick to control the orientaion of the jumper. This will take some practice. It is easy at first to lose control. If you do, just select Reset for the starting Flight condition. The main control is stick left or right in short pulses to start or stop a rotation in roll which is a change in the heading when you are flying straight downward. If you have rudder pedals, they can be used separately to control yaw which can be seen on the panel as a change in Beta (sideslip). If you use autocoordination for the rudder, the stick will control both roll and yaw together. That may work okay for some of you. It can become complicated.
The jumper will give the best forward track with his legs down and arms back by his side. You can see this track if you turn on smoke (the i key) and view from a spot on the ground (ie- control tower). Also, after pausing the Skydiver, you can look at World/Map and zoom in to see the actual track over the ground.
You will need to install the Parafoil as a separate aircraft and then Select it after you pause the Skydiver in order to finish the jump properly. Note that the / key will deploy a pilot chute from the Skydiver´s pack in preparation for the switch to the Parafoil. This is intended to be done just a few seconds before you change aircraft.
Have fun. I have tried to make this realistic within the limits of the sim. It is far from perfect but I think it is close to being realistic interms of the speeds reached and attitudes used.
voila si quelquin pourrait me l´expliquer ce serait vraiment tres simpas!!!!!!@+
