car je comprend pas tout car quand je v sur gestionaire de périphériques il me met enplacement pci
mais sur power strip il me parle de ça iagnostic report - generated on 15/12/2004
--------------------------------------------------
----------------------------
PowerStrip build - 488
Windows build - v.5.1.2600.2.Service Pack 2
DirectX build - v.5.03.2600.2180 ( xpsp_sp2_rtm.040803-2158)
OpenGL renderer - ( n/a)
System board
--------------------------------------------------
----------------------------
CPU speed - 1400 MHz
Type - VIA
AGP aperture - 64 MB
AGP transfer mechanism - DMA
AGP non-local memory - 30,8 MB
AGP driving value - 9Fh ( N-ctrl=9, P-ctrl=15)
AGP revision - 2.00
AGP transfer rates supported - 1x, 2x, 4x
Current AGP transfer rate - 4x
Sideband addressing - Enabled
Fast write protocol - ( n/a)
AGP texturing - Enabled
Graphics card #1
--------------------------------------------------
----------------------------
Identity - Giga-Byte Display controller
Memory clock - 155,25 MHz
Engine clock - 155,25 MHz
IRQ - 16, not shared
AGP revision - 2.00
AGP transfer rates supported - 1x, 2x, 4x
Current AGP transfer rate - 4x
Sideband addressing - Enabled
Display driver - ati2dvag.dll, v.6.13.3276 built by:ATI Technologies Inc.
DirectX driver - ati2dvag.dll, v.6.13.3276 built by:ATI Technologies Inc.
Attached monitor - Monitor A727 Packard Bell ( NEC Computers International)
Monitor caps ( 1) - 1280x1024, 70kHz, 120Hz
Device enumeration
--------------------------------------------------
----------------------------
VIA CPU-to-PCI/AGP bridge ( 03051106h)
VIA PCI-to-PCI bridge ( 83051106h)
VIA PCI-to-ISA bridge ( 06861106h)
Giga-Byte Display controller ( 51591002h) - using IRQ16
donc alors ma carte graphique est sur agp ou pci